Supplier Energy Audits in Thermal Power Plants
Kortelainen, Juha (2008)
Tiivistelmä
This master’s thesis handles an operating model for an electric equipment supplier conducted sale oriented energy audit for pumping, fan and other motor applications at power plants. The study goes through the largest factors affecting internal electricity use at a power plant, finds an energy audit –like approach for the basis of information gathering and presents the information needed for conducting the analysis. The model is tested in practice at a kraft recovery boiler of a chemical pulping mill. Targets chosen represent some of the largest electric motor applications in the boiler itself and in its fuel handling. The energy saving potential of the chosen targets is calculated by simulating the energy consumption of the alternatives for controlling the targets, and thereafter combining the information with the volume flow duration curve. Results of the research are somewhat divaricated, as all the information needed is not available in the automation system. Some of the targets could be simulated and their energy saving potential calculated quite easily. At some of the targets chosen the monitoring was not sufficient enough for this and additional measurements would have been needed to base the calculations on. In traditional energy audits, energy efficiency of pump and fan applications is not necessarily examined. This means that there are good possibilities for developing the now presented targeted energy audit procedure basis further. Tässä diplomityössä käsitellään toimintamallia sähkölaitetoimittajan suorittaman, tausta-ajatukseltaan myyntitarkoituksessa tehdyn energiakatselmuksen toteuttamiseksi voimalaitoksen pumppaus-, puhallin- sekä muissa moottorisovelluksissa. Työssä käydään läpi suurimmat voimalaitoksen omaan sähkönkulutukseen vaikuttavat tekijät, haetaan energiakatselmusmainen lähestymistapa tiedonhankinnan pohjaksi sekä esitellään analyysissä tarvittavat tiedot. Lähestymistapaa kokeillaan käytännössä erään sellutehtaan soodakattilalla, jossa tarkasteltavaksi valittiin muutamia suurimmista moottorikohteita sekä itse kattilan, että sen polttoaineenkäsittelyn alueilta. Kohteiden potentiaalinen energiansäästö on laskettu simuloimalla sen vaihtoehtoina olevien ohjaustapojen energiankulutus ja yhdistämällä tämä tieto virtaaman pysyvyyskäyrän tietoon. Tutkimuksen tulokset ovat kaksijakoiset, sillä kaikkia tarvittavia tietoja ole saatavilla automaatiojärjestelmästä. Osa kohteista pystyttiin simuloimaan ja niiden energiansäästöpotentiaali laskemaan varsin helposti. Osassa kohteista monitorointi oli tähän tarkoitukseen nähden riittämätöntä ja lisämittauksia olisi tarvittu laskennan perustaksi. Pumppauksen ja puhallinten energiankulutusta ei välttämättä selvitetä energiakatselmusten yhteydessä, joten työssä tehdylle pohjalle on olemassa hyvät jatkokehitysmahdollisuudet.