Mechanical Design of Hydraulic Vise
Xue, En (2008)
Tiivistelmä
The general task of clamping devise is to connect the parts to the machining centers so that the work piece could be fixed on its position during the whole machining process. Additionally, the work piece should be clamped easily and rapidly by the machine users. The purpose of this Master’s thesis project was to develop a product design and find out the dimensioning of a hydraulic vise system for Astex Engineering OY, which was taking care of the general principles of product design and development during the design process. Throughout the process, the needs of manufacturing and assembling were taken into consideration for the machinability and minimization of the cost of manufacturing. The most critical component of the clamping devise was modeled by FEM for the issue of strength requirements. This 3D model was created with Solidworks and FEM-analysis was done with Cosmos software. As the result of this design work, a prototype of the hydraulic vise was manufactured for Astex Engineering OY and the practical test. Yleisiä puristinlaitteen tehtäviä on kiinnittää työstettävä kappale työstökoneisiin siten että se pysyy paikallaan koko tyostön ajan. Lisäksi kappale tulee kyetä kiinittämään työtasolle nopeasti ja vaivattomasti. Tämän diplomityön tarkoituksena oli suunnitella ja mitoittaa hydraulinen puristinjärjestelmä Astex Oy:lle. Sen suunnittelussa huomioitiin yleiset tuotesuunnittelun ja tuotekehityksen periaatteet. Läpi koko suunnitteluprosessin huolehdittiin myös valmistuksen ja kokoonpanon vaatimuksista kuten osien työstettävyydestä sekä työstökustannusten minimoinnista. Laitteen kriittisimmistä komponenteista laadittiin FEM-mallit niiden lujuustarkastelua varten. 3D-mallit luotiin Solidworks ohjelmistolla ja FEM-analyysit Cosmos ohjelmistolla. Suunnittelutyön perustella tehtiin lopuksi hydraulisen puristimen prototyyppi Astex Oy:lle laitteen testausta varten.